Programming Menu > Resources Area - Barco Event Master E2 Lite User Manual

The following sections describe each part of the Programming page in detail:
• "Programming Menu > Resources area", page 117
• "Programming Menu > Diagram area", page 127
• "Programming Menu > Layer Modifier area", page 130
• "Programming Menu > Adjustment area", page 135
6.20 Programming Menu > Resources area
General
This part of the Programming page allows users to manage the available input resources. Sources are
created and defined from the available Inputs that were defined on the System Configuration page.
About Sources and Inputs
Source are defined from input signals. Multiple sources can be defined from the same input. After a source is
defined, then several attributes can be modified. These attributes are: color adjustments, crop, sharpness and
mask. By default, a source is automatically created for each Input. Up to 256 sources can be created form the
same input. As with inputs, sources can be defined from multiple connectors, ex: 4K or DL DVI and as a single
link or dual link.
The multiviewer displays input signals not sources.
Few words about Inputs, Sources and Layers
Input
• Definition: Any video signal connected to the Event Master series processor.
• Features:
- An input signal can be 2K (Single Link), Dual-Link or 4K (Ultra-HD) format.
- Depending on the resolution and type of the input signal, multiple connectors may be required to
connect an input signal to the Event Master series processor. The number of connectors required is
listed in the table below.
SDI
DVI
HDMI 1.4a
DisplayPort 1.1a
• Adjustments:
- Name, Colorspace, Connector capacity, Auto Acquire, EDID, Contrast, Brightness, Gamma.
- Adjustments to an input signal have an effect on all sources that are derived from the input signal
Source
• Definition: A video signal created when an input is manipulated to create a desired look.
• Features:
- When an input is created, a source is automatically created with the same attributes as the input.
- Multiple sources can be generated from the same input signal.
- Any source can be dropped into any layer and any destination.
- The same source can be used in multiple layers and multiple destinations.
- It should be noted that if a source is used in multiple layers and a source is modified in one of the
layers, it will not be automatically updated in the other layers. To update the source in the other layers, it
needs to be deleted from these layers and re-inserted from the sources list.
• Adjustments:
- Name, Bind to User Key, Layer Aspect Ratio, Size, Position, Contrast, Brightness and Hue.
2K
Resolutions up to
2048x1200@60
1
1
1
1
EM GUI orientation
Dual Link
Resolutions up to
3840x1200@60
2
1
1
1
R5909934 /00 E2 Lite and EC-40
4K (Ultra HD)
Resolutions up to
4096x2160@60
4
2
2
2
117