Barco Event Master E2 Lite User Manual page 185

Each of the settings will allow for different size input / still and destination sources from the Input Resource tab
covered in the Programming Section below.
DL = Max 2560 x 1600 or 4095 x 1200
4K = Max 4096 x 2400 or 8192 x 1200
8L = Max 8192 x 2400 or 16384 x 1200
(Optional) Adjust Destination Parameters part 2 > Output Tab
From this menu you can:
1. See the output canvas (raster) size if more than one connector in the connector group used for the Aux
2. Choose more actions in sub tabs:
• Position:
- Enable Test Patterns with raster box and enable diagonal motion
- Define the Area of interest (AOI).
• Color:
- Perform color adjustments.
• Timing:
- Read the timing parameters associated with the selected format. Once a connector is in a connector
group, its Timing Parameters cannot be changed in the Destination
• Connector Settings:
- Select SDI type and SMPTE standards.
- Adjust the Connector Mapping from Horizontal to Vertical or Grid.
(Optional) Adjust Destination Parameters part 3 > Wide Tab
From this menu you choose between the two sub tabs:
• Data Double,
where you can adjust data Doubling parameters.
• Feathering,
where you can:
- adjust feathering parameters.
- turn Feather on or off per selection.
(Optional) Delete Destinations
1. Click on the blue button Delete Destination(s).
2. From the Name list click on the "x" space next to the output(s) you wish to delete. Or select the box to the right
of the EMP representation in the workspace.
3. Hit the red button Delete Destination(s) button. All of the selected Destination(s) will be removed from the list.
System Setup
R5909934 /00 E2 Lite and EC-40 185