Barco Event Master E2 Lite User Manual page 17

• Do not remove any covers or panels during normal operation. Removal any of these items will expose
sensitive electronic circuits and the unit may be damaged.
• During maintenance operations, always switch off the device and unplug power cords before removing one
of the covers.
• Always wear a wrist band which is connected to the ground while handling the ESD sensitive parts.
• Wear insulating gloves during the execution of the installation and maintenance actions to avoid short-
circuit.
• Be careful never to drop anything into the device assembly during the service procedures.
• Be careful to always follow the procedures during maintenance operations (spare parts replacement).
• This product is intended to operate from a power source that will not apply more than 230 volts rms
between the supply conductors or between both supply conductor and ground. A protective ground
connection by way of grounding conductor in the power cord is essential for safe operation.
• This product is grounded through the grounding conductor of the power cord. To avoid electrical shock,
plug the power cord into a properly wired receptacle before connecting to the product input or output
terminals. A protective-ground connection by way of the grounding conductor in the power cord is essential
for safe operation. For 110V installations the power supply cord should be rated at 13amps. For 220V
installations the power supply cord should be rated 10amps.
• Use only the power cord and connector specified for your product. Use only a power cord that is in good
condition. Refer cord and connector changes to qualified service personnel.
• Replace spare parts only with the same parts supplied by Barco.
• Save the original shipping carton and packing material. They will come in handy if you ever have to ship
your equipment. For maximum protection, repack your set as it was originally packed at the factory.
• Rated maximum ambient operating temperature, t
• Do not operate this product in an area containing explosive materials.
Safety Data Sheets for Hazardous Chemicals
For safe handling information on chemical products, consult the Safety Data Sheet (SDS). SDSs are available
upon request via safetydatasheets@barco.com.
= 40°C (104°F).
a
R5909934 /00
Safety
E2 Lite and EC-40 17