Event Master Series Processor Ascii Remote Control - Barco Event Master E2 Lite User Manual

Remote Control Protocol
B.1 Event Master series processor ASCII remote
control
General
The user can remotely control the Event Master series processor via a telnet connection to the unit's IP
address.
How to access the Event Master series processor remotely
To access the Event Master series processor remote commands, use the following procedure:
1. In a command prompt window, type a telnet command in the following format:
> telnet nnn.nnn.nnn.nnn 9878
where the n's represent the unit IP address and 9878 is the port.
2. Press Enter
The command prompt appears.
3. At the command prompt, type a specific Event Master series processor remote control command and press
Enter.
ASCII remote commands
This section lists the Event Master series processor remote commands, sorted by name.
ATRN
• Description: Performs an Auto Transition on the currently active destinations. The currently selected Effect
type, rate and edge width will be used to transition preview to program.
• Command Format: ATRN <transTime>
• Parameters:
<transTime> (optional)
Used to specify a transition time (duration of the transition) in frames. Value ranges from 0 to 1999. A 0
specify a cut transition. Any non-zero value (within range) will override the transition time in the controller. If
this argument is not specified, the current transition time known by the controller will be used.
• Examples:
> ATRN 200
(Transition Preview to Program on currently active destinations in 200 frames)
> ATRN 0
(Transition Preview to Program immediately. This is a CUT.)
> ATRN
(Transition Preview to Program using the transition time set in the controller)
• Query Format: N/A
• Query Response: N/A
PRESET
• Description: Preset Settings. For parameter details, see below.
• Command Format: PRESET
• Parameters:
-s (save preset, 1-1000)
-r (recall preset, 1-1000)
-a (recall preset and auto transition, 1-1000)
• Examples:
> PRESET -s 1
(Save currently selected destinations to preset 1)
> PRESET -r 10
(Recall preset 10)
PRESET -a 10
302 R5909934 /00 E2 Lite and EC-40