Barco Event Master E2 Lite User Manual page 93

Image 6-19: Configuration menu, Adjustment area, Output
The unit will query the connected device on its output for a preferred EDID and try to assign that as the output
resolution and frame rate. If no devices are connected, a standard HD resolution with the native rate of the
EMP is assigned as frame rate.
Next to the configuration name is the name of the Destination where the output is assigned. If the Output is not
assigned to any Destination, then the name will be "N/A".
The software by default names outputs as "Output 1, 2, 3..." The user can rename each output by
double clicking on the name and type in the new name in the blue box.
How to add Output
Outputs configurations can be added manually to unassigned connectors.
1. Click on the Add Output button.
The Add Output button is replaced by the Done Adding button (highlighted in blue).
2. In the System diagram area, click on the connector(s) that need to be assigned.
Connector(s) is immediately highlighted in blue.
3. The selection is completed by clicking the Done Adding button that is highlighted in blue.
A new Output is added in the output list.
How to delete Output
1. Click on the Delete Output(s) button
The Delete Output(s) button is replaced by the Delete Selected button (highlighted in red).
2. Click on the corresponding connector in the graphical area.
or
click in the "x" on the right hand side in the output configuration list.
Connector(s) is immediately highlighted in blue.
3. The deletion is completed by clicking the Delete Selected button.
Multiple connector configurations can be selected to be deleted together.
EM GUI orientation
R5909934 /00 E2 Lite and EC-40 93