Barco Event Master E2 Lite User Manual page 181

3. If you need to delete layers, click on the Blue button Delete layers.
(Optional) Edit the Name
1. Double click on "Destination1" in the Name list to edit the name.
2. When the area turns blue, click the eraser icon to clear the field.
3. Type a new name and hit enter when done.
(Optional) Adjust Destination Parameters
Click on the "Adjust" tab that is located on the top. In this Tab there are three sub tabs: Assign, Output and
Wide (See below).
(Optional) Adjust Destination Parameters part 1 > Assign Tab
From this menu you can:
1. Edit the name.
2. Change the Destination from Screen to Aux.
3. Set the dimensions if more than one connector.
4. Use the Auto Configure Output Format function that reads the EDID of the connected device and will produce
a signal like that if still within the rules of VESA timings.
5. Delete outputs.
6. Assign or Delete Layers.
(Optional) Adjust Destination Parameters part 2 > Output Tab
From this menu you can:
1. See the output canvas (raster) size.
2. See in what order and place the outputs populate the Destination.
3. Select outputs for manipulation.
4. Choose more actions in sub tabs:
• Position:
- Enable Test Patterns with raster box and enable diagonal motion
- Define the Area of interest (AOI).
• Color:
- Perform color adjustments.
• Timing:
- Read the timing parameters associated with the selected format.
• Connector Settings:
- Select SDI type and SMPTE standards.
System Setup
R5909934 /00 E2 Lite and EC-40 181