Barco Event Master E2 Lite User Manual page 233

Image 13-12: TCI card fansink pin locations
1
Fansink pins
CAUTION: Do not reuse a fansink, once it has been removed from the mainboard (PCBA). The
thermal compound will no longer be properly located, and the compression of the pins during
removal will prevent them from fastening properly to the motherboard. Use the fansink replacement
kit R767263K.
How to assemble a Tri-Combo Input (TCI) card
1. Install the fansink (heatsink fan) on the main board (PCBA), if the fansink is not already present.
1. Align the fansink pins with the holes on the PCBA.
2. Seat the pins so that they are flush with the top of the fansink.
3. Install the fan connector (not shown) to the connector on the PCBA.
4. Turn the card over and spread the fansink pins—using a small, flat-bladed screwdriver—to ensure that the
fansink stays attached to the card.
E2 Lite Maintenance
R5909934 /00 E2 Lite and EC-40 233