Setting Up The N X 64 Kbit/S Data Output Resources - Barco STELLAR User And Service Manual

4
N

Setting up the N x 64 kbit/s data output resources

To set up the N x 64
kbit/s data to decode
98

Setting up the N x 64 kbit/s data output resources

A program may contain several N x 64 kbit/s data signals or the N x 64 kbit/s data
signal may be placed outside the program in the transport stream.
Do as follows to set up the data output.
1. From the Codec Explorer right-click on the icon representing the program
containing the N x 64 kbit/s data you want to set up and select Properties.
2. Select the N x 64 kbit/s data signal to be decoded from the upper list.
The upper list contains the available PIDs from the active program. ROSA auto-
matically displays the PID of the selected N x 64 kbit/s data in the "PID" field.
3. Alternatively, set the PID manually in the commands field.
You click the Commands tab and type in the command
PROG:Nx64:SEL=MAN,PID. The manual selection is particularly useful
when you want to output an N x 64 kbit/s data signal which is in the transport
stream but not in the program.
4. Select Output 1 from the Output list.
The N x 64 kbit/s data is output on the N x 64 kbit/s connector. ROSA automati-
cally displays the output selection in the upper list.
Note! If you set output to None the N x 64 kbit/s data is not decoded at all.
Only the N x 64 kbit/s data PIDs are displayed in the upper list.
5. Click Apply.