About The System Menu; System Menu > Black Invalid - Barco Event Master E2 Lite User Manual

Image 5-7: Setup menu
From the Setup menu, you can configure certain system settings for the Event Master unit, display Technical
Support contact information, restore factory default settings, and check for available firmware updates. And
finally, you can save all the recent changes to the system.
The following sections describe each Setup Menu option in detail, except for the Code Upgrade feature. For
details about that option, refer to the chapter "Updating firmware", page 195:
• "About the System menu", page 53
• "Using the Tech Support menu", page 62
• "Restoring Factory Default Settings", page 62
• "Updating firmware", page 195
• "Save All", page 64

5.6 About the System menu

General
The System Menu, shown in the following illustration, allows you to view and change settings such as HDCP
status and Ethernet options. In this menu you can also backup or restore Event Master unit configuration,
obtain diagnostic information, adjust the intensity or lock the display screen.
Image 5-8: System menu
The following sections describe each Setup Menu option in detail:
• "System menu > Black Invalid", page 53
• "System menu > USB device (Backup/Restore)", page 54
• "System menu > Ethernet", page 57
• "System menu > VFD brightness (display brightness)", page 58
• "System menu > Diagnostics", page 58
• "System menu > Lock front panel", page 62
5.7 System menu > Black Invalid
General
The Black Invalid system setting determines whether the output is black when connected to a signal it cannot
process. Black Invalid is either On or Off. The default setting is On. This is a global setting, applicable to all
outputs.
Front Panel Menu orientation
R5909934 /00 E2 Lite and EC-40 53