Barco Event Master E2 Lite User Manual page 101

Image 6-23: Add destination buttons
If the Add destination button is pressed without selecting an output configuration, the software will
automatically assign the first unassigned output configuration (from left most output card) to a destination. The
output configuration format is copied to the destination output format.
New Screen or Aux destinations can be added as long as there are unassigned output configurations to
destinations.
Alternatively, you assign outputs to destinations by dragging them into the Destination block. In the example
below, the output 1 was assigned to ScreenDest1 and the destination format was set to 1920x1080 reflecting
the format of output1.
When output 2 is dragged into the same destination, then the format changes to 3840x1080 reflecting a 2x1
setup. When outputs are dragged into a destination in this manner, the software assumes it is a horizontal
setup with 0 pixel overlap. The overlap can be modified in the Wide menu. If a vertical or grid setup is desired,
then the output configuration needs to be setup as such in the output configuration menus.
Image 6-24: Add Output to Destination
EM GUI orientation
R5909934 /00 E2 Lite and EC-40 101