Connecting To Networks; Figure 2-8 Connecting To Ethernet Networks - Sun Microsystems StorEdge 5210 NAS Hardware Installation

5. Lift the bezel into position and press it onto the front of the chassis until it is
flush with the front.
6. Use the key to lock both bezel locks.

Connecting to Networks

Use the following procedures to connect the Sun StorEdge 5210 NAS to your
network. The network connectors can be found on the rear of the Sun StorEdge 5210
NAS server, as shown in the following illustration.
Network Interface Ports
Connecting to Ethernet Networks
FIGURE 2-8
Connecting to Fast Ethernet Networks
To connect the Sun StorEdge 5210 NAS server to an Ethernet network:
Connect an RJ-45 unshielded twisted-pair cable from the network to the Fast
Ethernet connector on the rear of the Sun StorEdge 5210 NAS server.
Connecting to Gigabit Ethernet Networks
To connect the Sun StorEdge 5210 NAS server to a Gigabit network:
Connect an RJ-45 unshielded twisted-pair cable to a 1000 Base T connection on
your network and to the rear of the Sun StorEdge 5210 NAS server.
Or
Connect an SC cable from the network to the optional optical Gigabit Ethernet
connector on the rear of the Sun StorEdge 5210 NAS server. (Two optical Gigabit
Ethernet connections are optional add-ins.)
Chapter 2 Installing the Sun StorEdge 5210 NAS 17