Nck/Plc Interface Signals - Siemens SINUMERIK 840DiE sl Manual

13 Axis and Spindle Test Run
13.1 Prerequisites
References
13.1.3

NCK/PLC interface signals

References
13-422
The following terminals must be connected:
I/RF module
Terminal Significance
63 Impulsfreigabe
64 Drive enable
48 DC–link start
Drive Module
Terminal Significance
663 Impulsfreigabe
Signal TRUE: +24 V (e.g. from terminal 9)
/FBU/ SIMODRIVE 611 universal Description of Functions
/POS3/ SIMODRIVE SI/CD/CA User Manual
The following NCK/PLC interface signals must be set:
DB number Byte.Bit
31, ... 0
31, ... 1.3
31, ... 1.4
31, ... 1.5
31, ... 1.6
31, ... 1.7
31, ... 2.1
31, ... 2.2
31, ... 4.3
31, ... 4.4
31, ... 4.6
31, ... 4.7
31, ... 5.0 – 5.5
31, ... 12.0
31, ... 12.1
31, ... 20.1
31, ... 21.7
1) Alternative
2) Checking the function of the hardware limit switch and the relevant interface signals
3) Function–dependent
/FB1/ Description of Functions Basic Functions
A2 Various Interface Signals and Functions
Value
<> 0% Feedrate/spindle override
FALSE Axis/spindle disable
FALSE Followup mode
TRUE Position measuring system 1
TRUE Position measuring system 2
TRUE Override active
TRUE Controller enable
FALSE Distance–to–go/Spindle reset
FALSE Feed stop/spindle stop
FALSE Traversing–key lock
3)
Traversing key –
3)
Traversing key +
3)
JOG/INC
2)
Hardware limit switch PLUS
2)
Hardware limit switch MINUS
FALSE Rampfunction generator rapid stop
TRUE Impulsfreigabe
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007
Significance
1)
1)