Siemens SINUMERIK 840DiE sl Manual page 431

01/2007
Traversing range
monitoring
Activating
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
– With PLC
Traversing of the axis to be measured is enabled in addition to the inter-
face signals typical for JOG mode depending on the interface signal.
"Drive test traversing enable".
The measuring functions have their own traversing range monitoring. With this
monitoring function the traverse range of an axis can be limited or monitored
without having to reference this axis.
The basis is the absolute axis position displayed in the "Status" group at the
time of measurement.
The traversing range monitoring is activated from the main menu of the ap-
propriate measuring function in the group "Traversing range". See Fig. 14-1,
page 14-430.
Choose the traversing range monitoring from the selection list "Monitoring" via
the Toggle key or by clicking with the right–hand mouse button on the required
monitoring type:
– Inactive
The axis is traversed without monitoring of the traversing range.
– Active
The axis is traversed with monitoring of the traversing range, depending
on the traversing range limits set:
– Upper limit
– Lower limit
14 Drive Optimization with HMI Advanced
14.3 Miscellaneous functions
Toggle key
14-431