Parameterization Of The Mcp - Siemens SINUMERIK 840DiE sl Manual

8 PROFIBUS DP Communication
8.7 DP slave: MCP 483
Automation
system
8.7.2

Parameterization of the MCP

Interfaces
Termination equipotential bonding conductor
Rotary switch X30/X31
LEDs 1...4
Customer-spec. operating elements X51
...X54
Fig. 8-17 Position of interfaces on rear side of machine control panel
Display of the
software version
8-210
/Z/ Catalog NCZ
Connection Components: Cables, connectors, etc.
To commission the MCP the automation system must be completely electrically
and mechanically connected with respect to NC, PLC and MCP.
The drives must be secured against accidental moving.
Fig. 8-17 below shows the interfaces on the rear of the module:
Power supply X10
(see below for details)
Keyswitch X50
For a detailed description of the electrical and mechanical design and of the
machine control panel interfaces, please refer to:
References: /BH/ Operator Components, Manual
Section: Machine control panel MCP 483
After the MCP has been electrically connected, all LEDs on the front side of the
MCP flash until communication is established between MCP and PLC.
Simultaneously pressing the two keys "Feed stop" and "Feed enable" (in the
bottom right corner) displays the version number of the current software version
using the LEDs now lighting continuously.
Version number = V "Number of lit LEDs on the left LED block"
"Number of lit LEDs on the center LED block"
"Number of lit LEDs on the right LED block"
PROFIBUS X20
Handwheels X60/X61
Handwheel signal type S1
COM board
Direct keys X70
S3 DIP switch
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007
Power supply X10
1 2 3
SHIELDM24 P24
.
.