Proposal For Terminal Assignment: 1St Cu With 2Nd - Nth Cu - Siemens SINUMERIK 840DiE sl Manual

9 Drive Commissioning (SINAMICS)
9.4 Further terminal assignments
Table 9-5 Terminal assignment of 2nd – nth CU (X122)
Pin no. Function
SH/SBC 1 – Group 2
8 Output
SINAMICS Safety Integrated
9
10 Input Bero 1 – zero mark substitute
Bero 2 – zero mark substitute
11 11 Input Input
2nd OFF 2
12
9.4.4 Proposal for terminal assignment: 1st CU with 2nd – nth CU
1st CU
X122
Pin
Line contactor
1
2
OFF 3
Infeed with DRIVE CLiQ connection:
Output X132.7 (p 0742) must be connected to parameter r 0863.0.
Fig. 9-6 Proposal for terminal assignment: 1st CU with 2nd – nth CU
9-270
Assignment
Ground for pins 7, 8, 10, 11
Ground for pins 7, 8, 10, 11
Note
The interconnection proposal refers to the terminal assignment proposals made
in the previous sections.
X132
Pin
Output: r 0863.0
"Infeed operation"
7
BICO source/sink
2nd – nth CU: p 739
CU: r 0722.10
CU: r 0722.11
CU: r 0722.11
2nd CU
X122
Pin
1
2
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007
p 9774.1
BICO from CU after
the first drive in the
group
Drive p 0495 = 2
Drive p 0495 = 3
Drive p 0845
nth CU
X122
Pin
1
2