Sinucom Nc - Siemens SINUMERIK 840DiE sl Manual

01/2007
15.2.3

SinuCom NC

Start
Creating a new file
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
SinuCom NC can be started as follows to create a series startup file:
S
SINUMERIK Desktop (see Section 5.4, Page 5-117)
Windows XP taskbar: Start > Programs > SinuCom NC > SinuCom NC
S
HMI Advanced
Operating area switchover > ETC key ">" SinuCom NC
Creating a series startup file with SinuCom NC is subdivided into the following
steps (see Fig. 15-2 below):
1. Starting SinuCom NC
2. Selecting the storage location
3. Selecting the components to back up (archive content)
4. Continuing ("Next >")
Create an archive
Fig. 15-2 Menu: Creating a series startup archive
5. The following data can be selected in the following menus, depending on
the selected components:
– NCK: Part programs
– MMC: MMC archives
6. Creating the series startup file ("Finish")
15 User Data Backup/Standard Commissioning
15.2 Creating a series commissioning file
Storage location
Data Storage
File system
Archive content
NC with compensation data
PLC
PROFIBUS drives
MMC
Next >
15-463