Siemens SINUMERIK 840DiE sl Manual page 505

01/2007
18.2 Expanded message frame configuration/evaluation of internal drive variables
Dialog box
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Dialog box: DP slave properties
Tab card: Configuration
Tab: Details
Actual value > Length: <Length standard PDA + length
additional PDA PDA>
Setpoint > I/O address: <I/O address actual value> (see above 2.)
OK
Notice
S
The setpoint and actual value of a drive must have the same I/O address.
Actual value: I/O address = = Setpoint: I/O address
S
The I/O address configured in HW Config for a drive must match the I/O
address set in the NCK.
There is no automatic adjustment!
The following data must agree:
1. SIMATIC S7 configuration of DP slave S120
I/O address
2. SINUMERIK 840Di sl NCK
MD13060: DRIVE_LOGIC_ADDRESS[n] (logical drive address)
Note
After increasing the length of the actual value PDA (dialog box: DP slave
properties > Configuration > Details > Actual value > Length), when the
Properties dialog box is opened again, in message frame type:
Dialog box: DP slave properties
Tab card: Configuration
Tab: Overview
Default: <Frame type>
the message frame type that was originally selected is no longer displayed, but
the message frame that matches the modified PDA or no message frame type.
18 840Di–specific Data and Functions
18-505