Drive Configuration - Siemens SINUMERIK 840DiE sl Manual

11 NCK Commissioning with HMI Advanced
11.5 Axes and spindles
Geometry axes
Machine data
Table 11-16 Axis names: Machine data
Number
General ($MN_ ... )
10000 AXCONF_MACHAX_NAME_T AB
Channel–specific ($MC_ ... )
20060 AXCONF_GEOAX_NAME_T AB
20080 AXCONF_CHANAX_NAME_T AB
References
11.5.3

Drive configuration

I/O addresses
11-314
Machine data
S
MD20060: AXCONF_GEOAX_NAME_TAB[n] (name of the geometry axis in
the channel)
is used to define the geometry axis names. Geometry axis names must be un-
ambiguous for the entire channel.
The axis names for channel and geometry axes are used in the part program for
programming general traversing movements or to describe the workpiece con-
tour. The axis names are used for
S
Path axes
S
Synchronized axes
S
Positioning axes
S
Command axes
S
Spindles
S
Gantry axes
S
Coupled axes
S
Guide value coupling axes
Identifier
Machine axis name
Geometry axis name in channel
Channel axis name/special axis name in channel
/FB/ Description of Functions, Basic Functions,
K2 Axes, Coordinate Systems, Frames, Workpiece Actual–Value System,
Chapter: Axes
The following data must be assigned parameters in the NCK for the cyclic pro-
cess data exchange between the NCK and the DP slave drives:
S
I/O address of the drives
S
I/O address of the Control Units (optional, only SINAMICS)
S
Message frame
The I/O address tells the NCK the data areas via which cyclic process data ex-
change occurs with the drive or the Control Unit.
The I/O addresses assigned in the SIMATIC S7 project are entered in the fol-
lowing machine data:
Name/remarks
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007
Refer-
ence