Drives Of Control Unit 2: Additional Bico Interconnection - Siemens SINUMERIK 840DiE sl Manual

01/2007
Creating a project
Component
topology
Commissioning
Infeed:
Operation
9.3.2

Drives of Control Unit 2: Additional BICO interconnection

© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
9.3 Example for systems with more than 6 drives
The project should be created according to the description from Section 9.2,
Page 9-243. Both drive units must be displayed in the preview window.
STARTER Project Wizard
1.
Introduction Create a
new project
Preview
Project
Drive_Unit_Addr10
Drive_Unit_Addr20
Fig. 9-2 STARTER: Project Wizard (excerpt)
The automatic acquisition of the component topology and configuration is per-
formed for each drive unit according to Section 9.2.2, Page 9-247.
The commissioning of the drive components must be performed in accordance
with the sections listed above: 9.2.3, Page 9-250 to Section 9.2.15, Page 9-262.
Parameter "p864, BI: Infeed operation" of all drives must be interconnected to
the corresponding signal of the infeed "r863: Bit0, Infeed operation".
S
Control_Unit_1
Drives controlled by Control_Unit_1 (Drive_1..._5) are interconnected auto-
matically.
S
Control_Unit_2
Drives controlled by Control_Unit_2 (Drive_6..._9) must be manually inter-
connected (see the following section).
The infeed can be connected with a Control Unit via DRIVE CliQ. Since Con-
trol_Unit_1 is connected with the infeed, it is not possible to make a BICO inter-
connection from drive parameter "p864, BI: Infeed operation" to the infeed sig-
nal "r863: Bit0, Infeed operation" for the drives controlled by Control_Unit_2
(Drive_6..._9).
S
Drive: p864, BI: Infeed operation
S
Infeed: r863: Bit0, Infeed operation
9 Drive Commissioning (SINAMICS)
2. 3.
Set PG/PC Insert Summary
interface drive
device
Refresh
view
4.
9-265