Siemens SINUMERIK 840DiE sl Manual page 36

1 General Information on the SINUMERIK 840Di sl
1.3 Notes on commissioning
Documentation
1-36
– Installation of additional software on the PCU
To install software on the PCU see Chapter 17, Page 17-477.
S
Communications link: PG/PC with NC, PLC and drives
– Ethernet cable
– MPI/PROFIBUS cable
Note
No programming device is required in the following cases:
– SIMATIC Manager STEP7 is installed on the SINUMERIK 840Di sl PCU
– A PG/PC is used to install additional software
To install software on the PCU, see Section 17, Page 16-467.
The following documentation is required for commissioning:
S
/BH/ Operator Components Manual
– Operator panel fronts
– PCU 50.3
– Machine control panels
– Operator panel, handheld terminal HT8
Depending on the NC and PLC functions used, the relevant Descriptions of
Functions:
S
/FB/ Description of Functions – Basic Functions
S
/FB/ Description of Functions – Extended Functions
S
/FB/ Description of Functions – Special Functions
S
/LIS/ Lists
– Overview of the functions
– Machine, Setting Data and Variables
– Interface Signals and PLC Blocks.
S
/DA/ Diagnostics Guide, Contents:
– Alarms
Drive commissioning:
S
SINAMICS
– SINAMICS S120 Commissioning Manual
S
SIMODRIVE
– /FBU/SIMODRIVE 611 universal and universal E
Closed–Loop Control Components for Speed Control and Positioning
– /POS3/SIMODRIVE SI and CD/CA
Distributed Servo Drive Systems
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007