Cable Distributor - Siemens SINUMERIK 840DiE sl Manual

01/2007
2.4

Cable distributor

Order number
Cable connection
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
Designation
Cable distributor
The cable distributor consists of a connector jacket for a 37–pin Sub–D connec-
tor with enlarged interior. The cable distributor is used to split the I/O electronic
handwheel extension interface (X121) to a maximum of 7 single cables. These
must be connected in the order shown in Table 2-9, Page 2-63.
To supply the digital outputs, an external 24 V supply is possible at the cable
distributor.
Fig. 2-10 Cable distributor
Insert the appropriate individual cable in the opened cable distributor at the as-
sociated connector X1 to X10. Place the cable in the appropriate cable guide.
Make sure that the shield jackets that became free have a large conductive
connection to the metallic contact areas of the cable distributor. See Fig. 2-11,
Page 2-62. Locate the upper terminal bar in such a way that its "teeth" are fac-
ing the "teeth" of the lower terminal bar and then retain the upper housing sec-
tion.
2 Hardware Descriptions
2.4 Cable distributor
Order No. (MLFB)
6FX2 006–1BA02
Cable
6FX2002–4AA21–0jjj
Cable
6FX2002–4AA41–0jjj
90
2-61