Dp Slave: Mcp 483 - Siemens SINUMERIK 840DiE sl Manual

01/2007
8.7

DP slave: MCP 483

Fig. 8-16 MCP 483Front panel; Version T (turning machines)
8.7.1 Conditions for general commissioning
Hardware
Software
References
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
The following hardware is required:
S
PROFIBUS connecting cable
No terminating resistor is integrated in the machine control panel.
The following software is required:
S
PLC basic program
The relevant modules of the basic PLC program are FB 1 (MCP commu-
nication parameters), FC 19 (interface parameter assignment version: mill-
ing) and FC 25 (interface parameter assignment, version: turning).
The library of the PLC basic program is part of the SINUMERIK 840Di sl.
How to install the library is described in Section 6.4, Page 6-152.
S
SIMATIC STEP 7
SIMATIC STEP 7 is needed to customize the PLC basic and user programs
to the requirements of the respective automation system. SIMATIC STEP7
can be installed directly on the PCU of the SINUMERIK 840Di sl. How to
install additional software is described in Section 17, Page 17-477.
S
DP slave: MCP 483
The DP slave: MCP 483 is part of the PLC Toolbox. When the PLC Toolbox
is installed, it is automatically installed in SIMATIC STEP 7.
The following manuals are required for the commissioning of the MCP:
/FB1/ Description of Functions, Basic Functions
P3, PLC Basic Program
Program structure and modules of the PLC basic program.
/FB2/ Description of Functions, Extended Functions
H1 Jog with/without Handwheel
Commissioning of handwheels
/BH/ Operator Components Manual
Description of MCP (interfaces, electrical connection, etc.)
8 PROFIBUS DP Communication
8.7 DP slave: MCP 483
8-209