External Hmi Advanced - Siemens SINUMERIK 840DiE sl Manual

7 Ethernet Communication

7.4 External HMI Advanced

7.4 External HMI Advanced
Requirements
HMI configuration
7-164
If the SINUMERIK HMI Advanced user interface is not installed on the
SINUMERIK 840Di sl PCU, but on an external computer, e.g. PCU 50.3
with OP 012 (referred to as HMI PCU), there must be an Ethernet connection
established between both computers.
External computer:
PCU 50.3 with OP 012
SINUMERIK 840Di sl PCU
Ethernet 2 (system network)
Default setting:
– DHCP server
– IP address: 192.168.214.241
– Subnet mask: 255.255.255.0
Fig. 7-2 Example of a possible Ethernet connection
Note
There are no restrictions in terms of Ethernet topology within the SINUMERIK
840Di sl PCU and HMI PCU.
The following conditions must be fulfilled:
S
There is an Ethernet connection between SINUMERIK 840Di sl PCU and
HMI PCU and both computers communicate.
S
The communication parameters of the SINUMERIK 840Di sl PCU Ethernet
interface with which the HMI PCU is connected are known.
To check an Ethernet connection, see Section 7.1.3, Page 7-162.
The configuration of HMI Advanced, with respect to the Ethernet connection to
the SINUMERIK 840Di sl, is performed as follows:
1. Start HMI Advanced.
2. Open the dialog for entering the IP address: Operating area switchover >
Installation > HMI > NCU connection> NCU address
3. Enter the IP address of the interface by which the HMI communicates with
the SINUMERIK 840Di sl.
Example:
Interface: Ethernet 2 (system network)
IP address: 192.168.214.241 (default)
Ethernet 1 (company network)
Default setting: DHCP Client
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
01/2007