First Power-Up - Siemens SINUMERIK 840DiE sl Manual

01/2007
5.2 First power–up
5.2.1 Basic commissioning of the system software
Objective of basic
commissioning
Factory settings
Installing the
software
© Siemens AG 2007 All Rights Reserved
SINUMERIK 840Di sl Manual (HBIsl) – 01/2007 Edition
After the basic commissioning described in the following two sections, the fol-
lowing conditions should apply:
S
SINUMERIK 840Di sl NC and PLC are operated in cyclical operation
S
If a machine control panel is connected, no alarms or messages should be
pending.
S
The displayed axes of the NC can be traversed by simulation.
The hard disk of the PCU is already partitioned upon delivery for operating the
SINUMERIK 840Di sl. Additional software applications which have been been
ordered, e.g. HMI Advanced, are ready for installation under:
S
D:\Setup\Apps\<Application1> . . . <Application n>
C:
NTFS
Name: EMERGENCY
Content: WinPE 2005
Primary partition
Fig. 5-1 Partitioning the hard disk
When the PCU is first booted, the following menu is displayed:
These SINUMERIK products will be installed now:
Menu commands:
S
Install NOW
All the applications displayed will be installed in the listed order. During the
installation procedure follow the instructions that appear on the screen.
5 Power On and Power–Up
D: E:
NTFS
Name: TMP Name:
Content: Images, Content: Windows XP
Setups,
Updates
Extended partition with logic drives
Welcome to SINUMERIK !
<Application 1> <Version>
: :
: :
<Application n> <Version>
Install NOW
Install on NEXT REBOOT
CANCEL installation
5.2 First power–up
F:
NTFS NTFS
SYSTEM Name: USER
Content: 840Di sl
5-109