Connecting Cables To The Sj535A Water Sensor - Huawei IDS2000 Dual-Row Aisle Containment Installation Manual

IDS2000 Dual-Row Aisle Containment
Installation Guide (Split-type Skylight, Old-Version
Sliding Door)
Wiring Terminal in the ALM_IN Port
G
+
-

----End

10.12.17 Connecting Cables to the SJ535A Water Sensor

Prerequisites



Context
When connecting the water sensor and the CCU collector, you need to perform the following
steps to prepare a special monitoring cable.
Procedure
Step 1 Remove the rear cover from the water sensor to expose the interior panel, as shown in
10-54.
Issue 02 (2015-06-30)
If connected to an ECC, the monitoring cable should be connected by performing the
following steps.
a. Connect one end of the network cable to the Ethernet port on the water detector.
b. Connect the other end of the network cable to the AI/DI port on the ECC collector.
A monitoring cable required has been prepared.
You are familiar with the functions of all ports on the CCU collector by referring to
10.12.2 Port Description for the CCU
You are familiar with the functions of all ports on the ECC collector by referring to
10.12.3 Port Description for the ECC
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Core Wire in the Cord End Terminal
Core wire 8 (brown)
Core wire 7 (brown-white)
Core wire 6 (green)
Collector.
Collector.
10 Cable Layout
Figure
220