Remote Control; Interface Configuration; Configure To Usb Remote Interface; Configure The Lan And Lxi Interface - Promax AE-166 User Manual

6 REMOTE CONTROL

This chapter describes basic configuration of IEEE488.2 based remote control.
6.1

Interface Configuration

6.1.1

Configure to USB Remote Interface

USB configuration
►

PC side connector: Type A, host

AE-16X side connector: Rear panel Type B, slave

Speed: 1.1/2.0 (full speed/high speed)

USB Class: USB TMC (USB T&M class)
Panel operation
►
Connect the USB cable to the rear panel USB B port.
Press
toggle the USB mode to Device.
NOTE:
6.1.2 Configure the LAN Interface
The AE-166/167 can be configured for remote control or monitoring over a
LAN or WLAN. The AE-166/167 supports HiSlip. HiSlip (High-Speed LAN
Instrument
communications.
Background
►
The LAN interface is used for remote control over a network. The spectrum
analyser supports DHCP connections so the instrument can be automatically
connected to an existing network. Alternatively, network settings can also
be manually configured.
165
> More[F7] > RmtInterface Config[F1] > USB Mode and
It may take a few moments to switch USB modes.
Protocol) is an advanced LAN based standard for 488.2
February 2017