Creating A Limit (From Trace Data) - Promax AE-166 User Manual

Press Point Num[F1] and choose a point number to edit with the number
pad (must start at #1).
Press Frequency[F2] and set the frequency of the point.
Press Limit[F3] and set the amplitude level of the point.
All the points will be displayed in a limit line table at the bottom of the
display.
Repeat steps 3-5 for the remaining points (maximum of 10points. Points
can only be created in numerical order).
To delete the selected point, press Delete Point[F6].
Press Return[F7] > Save Limit Line[F5] to save the currently selected
limit line.
NOTE:
4.2.2

Creating a Limit (from Trace Data)

Description
►
Trace data can be used to create limit lines. A 10 point limit line is created
from the trace data at each grid division as well as the start and stop
frequencies.
Operation
►
Press
line.
Limit line: 1 ~ 5
Press Trace Data to Limit Line[F3].
The AE-166/167 is split into two screens. The top screen shows the
trace and limit lines and the bottom screen shows the limit line table.
135
Note that the limit lines are automatically sorted by
frequency (low  high).
> Edit Select Limit[F1] > Limit Line [F1] and choose a limit
February 2017