Promax AE-166 User Manual page 19

Blank: Unassigned setting icons.
Settings, Trigger, Pre-amp and USB settings:
Sweep mode icon that shows the sweep status.
Trigger icon that shows the trigger status.
Pre-amplifier icon that shows the Pre-amplifier status.
USB settings icon displays the status of the USB A port.
Status Icons: Displays the interface status, power source status and
alarm status, etc. See the Status Icon Overview for a list of the status
icons.
Frequency / Bandwidth settings: Displays the Start, Center and Stop
frequencies, RBW, VBW, Span and Sweep settings.
Entry/Message area: This area is used to show system messages, errors
and input values/parameters.
Sweep progress bar: The sweep progress bar shows the progress of slow
sweeps (greater than 2 seconds).
Trace and waveforms: Main display showing the input signals, traces,
limit lines and marker positions.
Status Icon Overview
3G Adapter
Demo Kit
PreAmp
AC
AC Charge
Alarm Off
Alarm On
February 2017
Indicates that the 3G adapter is
installed and turned on.
Indicates that the
installed and turned on.
Indicates that the pre amplifier is on.
Shown when running on AC power.
Shown when the
charging the battery.
Alarm buzzer output is currently off.
Alarm buzzer output is currently on.
demo kit is
AC power is
10