Promax AE-166 User Manual page 106

Press Depth Axis[F4] to set depth (vertical) parameters:

Ref.Value[F1]: Offsets the reference position as a percentage of the
vertical scale/div.

Ref.Pos[F2]: Sets the reference position of the waveform on a vertical
grid subdivision (1:10).

Scale/Div[F3]: Sets the vertical grid division scale when Auto Scale is
Off.

Auto Scale[F4]: Toggles auto-scaling execution.
Press Squelch[F6] to set carrier squelch level. The squelch setting will
suppress unwanted noise of a certain level.
Operation: trigger configuration
►
Press AF Trigger[F5]> Trigger Setup[F2] to set the triggering conditions:

Edge Slope[F1]: Sets the trigger to rising or falling edge.

Trigger Mode[F2]: Sets the triggering mode:
 Nor.: Normal trigger
 Sgl.: Single trigger


Trigger Level[F3]: Sets the trigger level as a percentage of the depth.
(The displayed level will only remain for a few moments).

Trigger Delay[F4]: Sets the trigger delay time: 0 to 1 ks
Press Return[F7] to return to the AF Trigger menu and to set the
remaining trigger options:

FreeRun[F1]: Disables the trigger, this is the default setting.

Start Time[F3]: Sets the start time for the x-axis for the AM waveform
in the top-half of the screen.

Stop Time[F4]: Sets the stop time for the x-axis for the AM waveform
in the top-half of the screen.

Action Now[F5]: Turns FreeRun mode off and uses the user-defined
trigger settings.
NOTE:
97
Cont.: Continuously trigger
The MAX and MIN measurements are held until higher or
lower values are found. To reset the MAX and MIN
measurements,
Analysis[F1] > Min/Max Reset[F3].
press >
Demod[F2] >
February 2017
AM