Table of Contents
Advertisement
SAFETY RULES
This chapter contains important safety instructions that you must follow during
operation and storage. Read the following before any operation to insure your
safety and to keep the instrument in the best possible condition.
Safety Guideline
General
*
Do not place any heavy object on the instrument.
*
Avoid severe impact or rough handling that leads to damaging the
instrument.
*
Do not discharge static electricity to the instrument.
*
Use only mating connectors, not bare wires, for the terminals.
*
Ensure signals to the RF input do not exceed +30 dBm / ±25 V DC.
*
Do not block the cooling fan opening.
*
Do not disassemble the instrument unless you are qualified.
*
(Measurement categories) EN 61010-1:2010 specifies the measurement
categories and their requirements as follows. The instrument falls under
category 2.
Power Supply
*
AC Input voltage range: 100 V ~ 240 V.
*
Frequency: 50 / 60 Hz.
*
To avoid electrical shock connect the protective grounding conductor of the
AC power cord to an earth ground.
Battery
*
Rating: 10.8 V, 6 cell Li-ion battery
*
Turn off the power and remove the power cord before installing or removing
the battery.
Cleaning
*
Disconnect the power cord before cleaning.
*
Use a soft cloth dampened in a solution of mild detergent and water. Do not
spray any liquid.
*
Do not use chemicals containing harsh material such as benzene, toluene
and acetone.
February 2017
Advertisement
Table of Contents
