Table of Contents
Advertisement
The display splits into two screens. The top screen shows the power
measurement in dBm or W. The bottom screen shows a graph of the
measurements.
Press Power Unit[F2] and choose the unit:
Unit: dBm, W
Press Frequency[F3] choose measurement frequency (use the number
pad):
Frequency: 1 MHz ~ 6200 MHz
Resolution: 1 MHz
Press Sensor Mode[F4] to choose measurement speed (and thus
accuracy) of the power meter:
Low Noise: 100 ms/sample, typical
Fast: 30 ms/sample, typical
To create pass fail tests, press Pass/Fail Test[F5] and set the following
parameters:
High Limit[F1]:
Low Limit[F2]:
Pass/Fail Test[F3]: On, Off
Pass Icon:
Fail Icon:
February 2017
Figure 119.
-30 dB m ~ 20 dBm
-30 dBm ~ 20 dBm
148
Advertisement
Table of Contents
