Table of Contents
Advertisement
Press any other main/control/file/marker /auxiliary key to exit out of the
System Information screen.
To upgrade the firmware, insert the new firmware onto a USB flash drive
or Micro SD card and put the drive/card into the appropriate front panel
port. The firmware files should be located in a local directory.
Press > More 1/2[F7] > Upgrade[F2].
The spectrum analyzer will automatically find the firmware on the USB
flash drive and start to update the firmware. When finished, the message
"Upgrade is finished" will be shown at the bottom of the screen followed
by "Rebooting".
The system will automatically restart after the rebooting message.
NOTE:
2.3.7
Restoring Default Settings
Description
►
The factory default settings or user presets can be easily restored using the
Preset key on the front panel. By default, the factory default settings are
restored with the Preset key.
Steps
►
Press
The spectrum analyser will load the preset settings.
2.3.8
Conventions
The following conventions are used throughout the user manual. Read the
conventions below for a basic grasp of how to operate the AE-166/167 menu
system and front panel keys.
17
The upgrade process may take a few minutes.
.
Figure 8
February 2017
Advertisement
Table of Contents
