Traking Generator (Only For Ae-167); Activate Tracking Generator - Promax AE-166 User Manual

4.4

Traking Generator (only for AE-167)

The tracking generator is a factory installed option that generates a sweep
signal with its sweep time and frequency range matching the AE-166/167.
The amplitude is maintained at a constant value over the entire frequency
range. This is useful for testing the frequency response of a DUT.

Activate the Tracking Generator

Normalize the Tracking Generator
4.4.1

Activate Tracking Generator

Operation
►
Press
generator on.
The TG OUTPUT will be activated.
Press TG Level[F2] to set the output level of the tracking generator.
Range: -50 to 0 dBm
Press TG Lvl Offset[F3] to set the offset level of the tracking generator to
compensate for system gain/loss.
Range: 0 dB to 50 dB
Press TG Lvl Step[F4] to set the step resolution of the TG level.
Range: Auto, Man; 0.5 to 50 dB, 0.5 dB step
Press Power Sweep[F5] to vary the output power of the TG to the rate of
the sweep. At the beginning of the sweep, the output power is at the set
TG Level and increases/decreases linearly to the set Power Sweep level
at the end of the sweep.
Range: -5 dB to +5 dB
February 2017
> Tracking Generator[F1] > TG[F1] and toggle the tracking
144