Promax AE-166 User Manual page 175

LAN configuration Settings
►
IP Address, Default Gateway, Subnet Mask, DNS Server, DHCP on/off.
Connection
►
Connect an Ethernet cable from the network to the rear panel
LAN port.
Settings
►
Press
to set the LAN settings:

IP Address[F1]: Sets the IP address.

Subnet Mask[F2]: Sets the subnet mask.

Default Gateway[F3]: Sets the default gateway.

DNS Server[F4]: Sets the DNS server address

LAN Config[F5]: Toggles the LAN configuration between DHCP and
manual settings.
Hint: Use dotted decimal notation when entering IP addresses, ie.,
172.16.20.8
Press Apply[F6] to confirm the LAN configuration settings.
Display Icon
►
The LAN icon turns green when connected to a LAN and will flash
if the "Identification".
Hi SLIP Port
►
Press
to see the Hi Slip Port number.
HiSlip port 4880
Reset LAN
►
It may be necessary to reset the LAN configuration settings before the LAN
can be used.
Press
reset the LAN.
It may take a few moments before the LAN is reset.
NOTE:
February 2017
> More[F7] > RmtInterface[F1] > LAN[F2] > LAN Config[F1]
> More[F7] > RmtInterface Config[F1] > LAN[F2] > HiSLIPPort
> More[F7] > RmtInterface Config[F1] > LAN Reset[F3] to
Each time the LAN is reset, the default password is
restored.
Default password: lxiWNpwd
166