Single Sweep; Continuous Sweep - Promax AE-166 User Manual

3.6.2

Single Sweep

Description
►
The single sweep function is used to perform a single sweep. When Sweep
Single is pressed the AE-166/167 will perform a single sweep and then
stop.
Operation
►
Press
sweep mode.
Press Sweep Single[F2] again to perform a single sweep.
When a single sweep has been performed, you can still perform
frequency, span, amplitude and other functions on the "frozen" trace.
Display Icon
►
The Sweep Single icon is displayed on the right-hand side of the
screen when the sweep is in single mode.
NOTE:
3.6.3

Continuous Sweep

Description
►
The AE-166/167 has two main sweeping run modes: single and
continuous. Use the continuous mode to have the sweep constantly updated.
Operation
►
Press
sweep mode.
Display Icon
►
The Sweep Cont icon is displayed on the right-hand side of the
screen when the sweep is in continuous mode.
NOTE:
February 2017
> Sweep Single[F2] to put the spectrum analyser into single
You must wait for the single sweep to finish before pressing
the Single Sweep key again.
If a setting is changed whilst the spectrum analyser is still
sweeping, the single sweep will immediately start over.
> Sweep Cont[F3] to put the spectrum analyser into continuous
The AE-166/167 will now continuously sweep unless the
mode is changed to single sweep mode or if the system is
waiting for a trigger condition.
48