Limit Line Testing; Creating A Limit (Point By Point) - Promax AE-166 User Manual

4.2

Limit Line Testing

The limit line is used to set the upper or lower amplitude limits over the entire
frequency range. The limit lines can be used to detect whether the input signal
is above, below or within the limit lines.
The limit lines can be manually or automatically created. The limit lines can be
manually edited by frequency or from the trace data or marker points.


Creating a Limit (Point by Point)


Creating a Limit (from Trace Data)

Creating a Limit (from marker data)

Creating a Limit (from marker data)

Delete Limit Line

Pass Fail Testing
4.2.1 Creating a Limit (Point by Point)
Description
►
Create a limit manually, point by point. A maximum of ten points can be used.
Operation
►
Press
line.
Limit line: 1 ~ 5
Press Point by Point[F2].
The AE-166/167 is split into two screens. The top screen shows the
trace and limit lines and the bottom screen shows the limit line table.
February 2017
> Edit Select Limit[F1] > Limit Line [F1] and choose a limit
Figure 105.
134