Promax AE-166 User Manual page 127

Pre-Set Test Parameters: 3GPP
►
For details on 3GPP SEM test parameters.
Press Setup[F1] > 3GPP[F1] to choose 3GPP measurement.
Press Ref. Channel[F2] and set the following:
RBW[F3]: Sets the resolution bandwidth.
All other reference channel settings are pre-defined.
Press Return[F7] to return the previous menu.
Press Offset/Limit[F3]>Duplexing Mode[F1] and choose FDD or TDD
duplexing:
For FDD, press FDD Setup[F2] set the FDD parameters, for TDD, press
TDD Setup[F3]:

Transmission[F1]: Toggles between BS and UE testing

Chip Rate[F2]: Selects the bandwidth of the RRC filter that is used to
measure the in-channel power for TDD duplexing:
3.84 MHz, 1.28 MHz, 7.68 MHz

Max Out Pwr[F2/F3]:
Sets the maximum output power for BS tests:
P > = 43
39 < = P < = 43
31 < = P < = 39
P < 31

Add.limits[F4]
Selects the operating bands for FDD duplexing: None
BandII
BandIV
BandV
BandX
BandX11
BandXIII
BandXIV

MinOffset/Limit Value[F5]: Allows you to view the parameters of each
of the offsets, including Stara / stop frequency, RBW, Abs Start / Stop
and Rel Start / Stop.
February 2017
118