Settings Menu; Status Tab; Network Tab; System Tab - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.11. Settings Menu
INFO:
The Settings menu is available for the transmitter, receiver and the transceiver separately. You can
choose which device you want to configure.
INFO:
The available settings are the same for all operation modes.
6.11.1. Status Tab
Status tab in the Settings menu (TX)
The most important hardware and software related information can be found on this tab: hardware and
firmware version, serial numbers, temperatures, operation time, and voltage information. Device label
can be changed to unique description.
#operationmode #transmitter #receiver #transceiver #tx #rx #trx
Operation Mode
The operation mode - the unit works as a transmitter or receiver - can be set on the Status tab. Follow the
steps to change the current operation mode:
Step 1. Select the desired Operation mode (Transmitter / Receiver / Transceiver mode).
Step 2. Confirm your selection, press OK.
Step 3. Wait until the device reboots. After booting up the endpoint operates in the selected operation mode.
Identify the Unit
Clicking on the Identify unit button makes the four front panel LEDs blink in green for 10 seconds. The feature
helps to identify the device itself in the rack shelf.
#status #firmwareversion #mac #identifyme #devicelabel #label
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
6.11.2. Network Tab
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button. See the factory default settings of the
endpoint device in the
6.11.3. System Tab
Three functions are available under System tab:
▪ System log - saving the file of the device.
▪ Factory defaults - recalling factory defaults settings and values. All factory default settings f the endpoint
device are listed in the
▪ Reboot - rebooting the system.
Network tab in the Settings menu
Factory Default Settings section. #network #ipaddress #dhcp
System tab in the Settings menu
#log
Factory Default Settings section. #factory
#restart #reboot
70 70