Frc - Output Side (Rx Mode); Hdmi Output Ports (Rx/Trx Modes); Sfp+ Link Panels (Tx/Rx/Trx Modes) - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.5.7. FRC - Output Side (RX Mode)
Clicking on the FRC (Frame Rate Converter) panel on the HDMI output
2 of the receiver opens the properties of the Frame rate converter.
#csc #colorspace
FRC panel for the HDMI out 2 (RX)
Available settings and tools:
▪
Output resolution mode
– Passthrough: the FRC is in pass-through mode.
– Forced resolution: the FRC is active, the selected value in the
forced resolution option will be applied on the video signal;
– EDID based: the FRC forces the resolution which is read out
from the EDID of the connected sink device.
▪ Forced resolution: list of the available resolutions with refresh
rate values. The selected one will be applied on the display
device. See the available resolution in the
Scaler / FRC section.
▪ Color space conversion (No conversion / RGB / YUV 4:4:4 /
YUV 4:2:2);
▪ No Sync Screen (Test Pattern) settings;
▪ Reloading factory default settings for the selected port.
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
6.5.8. HDMI Output Ports (RX/TRX Modes)
Clicking on the HDMI output 1 or 2 port icon results opening the Port
#frc properties. The most important signal and display information and
settings are available on the panel:
#freerun #sourcelocked
Port properties window of the HDMI out 1 (RX)
Available settings and tools:
Resolutions of the
▪ Port naming;
▪ HDCP mode (Auto / Always);
▪ Power 5V mode (Auto / Always on / Always off);
▪ Timing mode (Free run / Source locked).
Frame Detector;
▪
▪ Identify Stream / Identify Display
▪ Reloading factory default settings for the selected port.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
6.5.9. SFP+ Link Panels (TX/RX/TRX Modes)
Clicking on the SFP+ Link 1 or 2 panel opens the properties of the
SFP+ connections. The most important signal information and the
#hdcp #power5v #timingmode parameters of the SFP+ transceiver module or DAC cable are available
on the panel.
button;
#sfp
SFP+ Link 1 properties panel (TX)
61 61