Stream Switcher / Stream Tiles; Link Aggregation Status Indicator; Identifystream #Identifydisplay - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.5.10. Stream Switcher / Stream Tiles
The incoming streams from the transmitter can be routed to the HDMI
output 1 and/or 2 ports of the receiver.
Legend of the Stream Tiles
Signal
Tile Selected
present
 
Stream 1
Signal is not present and stream is not selected.
 
Stream 1
Signal is not present but stream is selected.
 N/A
Stream 1
The stream is disabled and not selected.
 N/A
Stream 1
The stream is disabled but selected.
 
Stream 1
Signal is present, stream is enabled, but bandwidth
is not enough for the transmission.
 
Stream 1
Signal is present, stream is selected and enabled,
but bandwidth is not enough for the transmission.
 
Stream 1
Signal is present, stream is selected, and the
bandwidth is OK.
INFO:
The maximum available bandwidth with the endpoint device
is 20 Gbps which requires 2x 10 GbE SFP+ module or DAC cable to
install. If one 10 GbE SFP+ module is installed only but the signal
is 4K@60 Hz (which requires ~14 Gbps to transmit), the stream tile
will be yellow.
INFO:

the HDMI in 1 on the TX side and the stream of the HDMI out 1 on the
RX side will be enabled at the expense of the HDMI in 2 / HDMI out 2.
#switch #crosspoint
See more information in the
INFO:

resolutions in the
Stream SFP+ link
enabled bandwidth
6.5.11. Link Aggregation Status Indicator
N/A N/A
N/A N/A
 N/A
 N/A
INFO:

the
 
aggregation problems.
 
 
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
When the signal bandwidth limit is exceeded, the stream of
Bandwidth Limitation section.
You can find the bandwidth requirements belong to each
Required Bandwidth of the Resolutions
Icon Description
SFP+ connection is established successfully and the
link aggregation is working successfully.
!
Waiting for the link aggregation.
!
No connection is established between the SFP+
links.
You can find possible causes and solution suggestions in
Troubleshooting chapter in the case of no connection or link
6.5.12. Identify Stream / Identify Display
Clicking on the Identify Stream / Identify Display button makes
generating 10 test colors on the display device for 10 seconds. The
feature helps to identify the stream and the screen itself physically.

#identifystream #identifydisplay

section.
The order of the test colors in the Identify stream feature
The feature is available on the following panels:
▪ Scaler Panel - Input Side (TX Mode)
▪ FRC - Input Side (TX/TRX Modes)
▪ HDMI Output Ports (RX/TRX Modes)
62 62