Lightware UBEX-PRO20-HDMI-F110 User Manual page 107

 
     
7. Programmers' Reference 7. Programmers' Reference
EDID Management
Query the Emulated EDIDs
ç GET•/EDID.EdidStatus
Query the Validity of a Dynamic EDID
ç GET•/EDID/D/<dynamic>.Validity
Query the Preferred Resolution of a User EDID
ç GET•/EDID/U/<user>.PreferredResolution
Emulating an EDID on an Input Port
ç CALL•/EDID:switch(<dynamic|user|factory>:<emulated>)
Copy an EDID to User Memory
ç CALL•/EDID:copy(<dynamic|emulated|factory|user>:<user>)
Deleting an EDID from User Memory
ç CALL•/EDID:delete(<user>)
Resetting the Emulated EDIDs
ç CALL•/EDID:reset()
Network Configuration
Query the DHCP State
ç GET•/MANAGEMENT/NETWORK.DhcpEnabled
Change the DHCP State
SET•/MANAGEMENT/NETWORK.DhcpEnabled=<logical_value>
ç
Query the MAC Address
ç GET•/MANAGEMENT/NETWORK.MacAddress
Query the IP Address
ç GET•/MANAGEMENT/NETWORK.IpAddress
Change the IP Address (Static)
SET•/MANAGEMENT/NETWORK.StaticIpAddress=<IP_address>
ç
Query the Subnet Mask
ç GET•/MANAGEMENT/NETWORK.NetworkMask
Change the Subnet Mask (Static)
SET•/MANAGEMENT/NETWORK.StaticNetworkMask=<netmask>
ç
Query the Gateway Address
ç GET•/MANAGEMENT/NETWORK.GatewayAddress
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
Change the Gateway Address (Static)
SET•/MANAGEMENT/NETWORK.StaticGatewayAddress=<gw_address>
ç
Apply Network Settings
ç CALL•/MANAGEMENT/NETWORK:ApplySettings()
Query the IP Address of the Remote Endpoint
ç GET•/REMOTE.RemoteIpAddress
RS-232 Port Configuration
Query the Current Configuration
ç GET•/MEDIA/UART/<port>.Rs232Configuration
BAUD Rate Setting
SET•/MEDIA/UART/<port>.Baudrate=<number>
ç
Parity Setting
SET•/MEDIA/UART/<port>.Parity=<number>
ç
Stopbits Setting
SET•/MEDIA/UART/<port>.StopBits=<number>
ç
Databits Setting
SET•/MEDIA/UART/<port>.DataBits=<number>
ç
Command Injection TCP Port Setting
SET•/MEDIA/UART/<port>.CommandInjectionPort=<port>
ç
Infrared Port Configuration
Enable/Disable the Port
SET•/MEDIA/IR/<in|out>.Enable=<logical_value>
ç
Enable Command Injection
SET·/MEDIA/IR/<in|out>.CommandInjectionEnable=<logical_value>
ç
Change Command Injection Port Number
SET·/MEDIA/IR/<in|out>.CommandInjectionPort=<port_no>
ç
Enable/Disable Output Signal Modulation
SET·/MEDIA/IR/<out>.EnableModulation=<logical_value>
ç
107 107