Lightware UBEX-PRO20-HDMI-F110 User Manual page 122

 
     
11. Assembly Guides 11. Assembly Guides
Step 5. Remove the front plate from the chassis.
Step 6. Push out the four light pipes from the front plate starting from the
rear side of the plate.
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Insertion of the New Front Plate
Step 1. Insert the four light pipes to the new front plate starting from the
front side of the plate. Take care of the direction of the light
pipes.
Step 2. Place the front plate to the chassis.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
Step 3. Fasten all the six screws on the front plate using the PZ1
screwdriver.
Step 4. Insert the jog dial knob to the holder so that fixing screw hole shall
be over the flat part of the holder.
122 122