Identify Stream; Resolution Setting; Resolution Mode Setting; Scaler - Image Position Setting - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
7. Programmers' Reference 7. Programmers' Reference
7.4.6. Identify Stream
Calling the method makes generating 10 test colors on the display device for 10 seconds. The feature helps
to identify the stream and the screen itself physically.
Command and Response #identifystream
ç CALL•/MEDIA/VIDEO/<source>:identify()
æ mO•/MEDIA/VIDEO/<source>:identify
Example
ç CALL /MEDIA/VIDEO/S1:identify()
æ mO /MEDIA/VIDEO/S1:identify
Explanation
7.4.7. Resolution Setting
The resolution which is set here will be enforced only on case of the ResolutionMode is set to Forced. See the
details about the Resolution Mode Setting in the next section.
Command and Response
SET•/MEDIA/VIDEO/<source>.ResolutionSetting=<resolution>
ç
pw•/MEDIA/VIDEO/<source>.ResolutionSetting=<resolution>
æ
Example
ç SET /MEDIA/VIDEO/S2.ResolutionSetting=1600x1200p60
æ pw /MEDIA/VIDEO/S2.ResolutionSetting=1600x1200p60

INFO: The entire list of available resolutions can be found in the
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Resolutions of the Scaler / FRC section.
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
7.4.8. Resolution Mode Setting
Command and Response
SET•/MEDIA/VIDEO/<source>.ResolutionMode=<resolution_mode>
ç
pw•/MEDIA/VIDEO/<source>.ResolutionMode=<resolution_mode>
æ
Parameters
Identifier Parameter description
Resolution mode
<resolution_mode>
setting
Example
ç SET /MEDIA/VIDEO/S1.ResolutionMode=Forced
æ pw /MEDIA/VIDEO/S1.ResolutionMode=Forced
7.4.9. Scaler - Image Position Setting
The image position setting which is set here will be enforced only in case of the ResolutionMode is set to
Forced. See the details about the Resolution Mode Setting in the previous section.

ATTENTION! The scaler settings are available for the stream of the HDMI input 1 port only. HDMI input 2
will always center the input image on the output image of enforced resolution.
Command and Response
SET•/MEDIA/VIDEO/<source>.ImagePosition=<image_position>
ç
pw•/MEDIA/VIDEO/<source>.ImagePosition=<image_position>
æ
Parameters
The <image_position> can be set to Center, Stretch or Fit.
Example
ç SET /MEDIA/VIDEO/S1.ImagePosition=Fit
æ pw /MEDIA/VIDEO/S1.ImagePosition=Fit
#scaler #frc
Value Explanation
Pass-through mode - the original stream is
Pass
transmitted to the receiver.
The transmitter forces the resolution set
Forced in the ResolutionSetting for the stream and
transmits it to the receiver.
82 82