Set The Scaler And The Frame Rate Converter - Lightware UBEX-PRO20-HDMI-F110 User Manual

 
     
3. Installation 3. Installation
Example
For HDMI in 1
In our example the incoming signal on the HDMI in 1 port is 4K UHD 60 Hz (3840x2160p@60Hz 4:4:4).
Select the F137 memory address on the left side and also select the E1 EDID memory slot on the Emulated
side. Click on the Transfer button (the arrow in the middle) to emulate the selected EDID.
For HDMI in 2
In our example the HDMI in 2 port receives 1080p60 Hz signal (1920x1080p@60Hz).
Select the F48 memory track on the left side and also select the E2 EDID memory slot on the Emulated side.
Click on the Transfer button (the arrow in the middle) to emulate the selected EDID.
EDID Management menu in the LDC
TIPS AND TRICKS:
If there is no pre-installed factory EDID in the list which can fit with your system, a new
EDID can be created via the EDID Creator wizard. See more details about it in the
EDID Creator section.
UBEX series – Extender Application Mode – User's Manual UBEX series – Extender Application Mode – User's Manual
Creating an EDID - Easy
Applied F-series endpoint firmware package: v1.4.1 | Applied R-series endpoint firmware package: v1.4.1 | LDC software: v1.34.0b2
3.6.7. Set the Scaler and the Frame Rate Converter
Set up the scaler and the frame rate converter (FRC) for the best user experience. The forced resolution and
refresh rate are recommended to fit the supported resolution / refresh rate of the sink device.

ATTENTION! Both input and output ports have FRC and CSC functions but the scaler is available for the
HDMI in 1 and HDMI out 1 ports only.
Scaler - Example
In our example the sink device is a 4K-ready
monitor and we have to display a 4K60 Hz
video on it. The signal is transmitted on
the HDMI out 1 port of the UBEX receiver.
Navigate to the Crosspoint menu - Video tab
and select the Scaler panel on the receiver
side. Set the Scaling Mode setting to EDID
based which means the receiver read out
the EDID of the sink device and scaling
the image to that. In our example it is
3840x2160p60.Set the Image position to Fit,
the Color space conversion to YCbCr 4:4:4.
Frame Rate Converter - Example
In our example the other sink device is a
full HD monitor with 50 Hz refresh rate
and we have to display a 1080p60 Hz
video on that. The signal is transmitted on
the HDMI out 2 port of the UBEX receiver.
Navigate to the Crosspoint menu - Video tab
and select the FRC panel on the receiver
side. Set the Output resolution mode to
Forced resolution, the Forced resolution to
1920x1080p50, the Color space conversion
to RGB.

TIPS AND TRICKS: The stream and the connected display device can be identified by using the
Stream / Identify Display feature. It makes generating 10 test colors on the display device for 10 seconds.
33 33
Identify