7.LW3Programmer'sReference
7.5.22.3. Test Pattern
Command and Response
SET·/MEDIA/VIDEO/<out>.TpgPattern=<pattern>
pw·/MEDIA/VIDEO/<out>.TpgPattern=<pattern>
Parameters
Identifier
Parameterdescription
<pattern>
Selectabletestimage.
RED / GREEN / BLUE / BLACK / WHITE /
RAMP / CHESS / BAR / CYCLE
Cyclesettingmeansallpatternsarechangedsequentiallyapprox.inevery2seconds.
Example
#nosyncscreen #testpattern
SET/MEDIA/VIDEO/O1.TpgPattern=GREEN
pw/MEDIA/VIDEO/O1.TpgPattern=GREEN
7.5.23. Querying the HDMI Mode Setting (Output Port)
Command and Response
#signaltype
GET·/MEDIA/VIDEO/<out>.HdmiModeSetting
pw·/MEDIA/VIDEO/<out>.HdmiModeSetting=<HDMI_mode>
Parameters
Identifier
Parameterdescription
<HDMI_mode>
Current mode of the
video port.
The AutomodemeanstheoutgoingsignaltypeisbasedontheEDIDofthesinkconnectedtothegiven
outputport.IfHDMIissupportedbytheEDID,thesignaltypewillbeHDMI,otherwiseDVI.
Example
GET/MEDIA/VIDEO/O1.HdmiModeSetting
pw/MEDIA/VIDEO/O1.HdmiModeSetting=2
Parametervalues
Parametervalues
0: Auto,thesignaltypeisbasedontheEDID-seebelow.
1: DVI istheoutgoingsignaltype.
2: HDMIistheoutgoingsignaltype.
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
HDMI-TPS-TX200series–User'sManual
7.5.24. Setting the HDMI Mode Setting (Output Port)
Command and Response
SET·/MEDIA/VIDEO/<out>.HdmiModeSetting=<HDMI_mode>
pw·/MEDIA/VIDEO/<out>.HdmiModeSetting=<HDMI_mode>
Parameters
Seetheprevioussection.
Example
SET/MEDIA/VIDEO/O1.HdmiModeSetting=0
pw/MEDIA/VIDEO/O1.HdmiModeSetting=0
7.5.25. Querying the TPS Mode of the Transmitter
ThefinallyestablishedTPSworkingmodebetweenthetransmitterandthereceiverisdeterminedbythe
settingoftheTPSportsofbothdevices.SeemoreinformationintheTPSInterface
Command and Response
#tpsmode
GET·/REMOTE/D1.tpsModeSetting
pw·/REMOTE/D1.tpsModeSetting=<TPS_mode>
Parameters
Identifier
<TPS_mode>
Current mode of the
TPSport.
Example
GET/REMOTE/D1.tpsModeSetting
pw/REMOTE/D1.tpsModeSetting=H
7.5.26. Setting the TPS Mode of the Transmitter
Command and Response
SET·/REMOTE/D1.tpsModeSetting=<TPS_mode>
pw·/REMOTE/D1.tpsModeSetting=<TPS_mode>
Parameters
Seetheprevioussection.
Example
SET/REMOTE/D1.tpsModeSetting=H
pw/REMOTE/D1.tpsModeSetting=H
Parameterdescription
Parametervalues
A: Auto
L: Longreach
H: HDBaseT
1:LPPF1
76
section.
2:LPPF2