Scaler Panel - Output Side (Rx/Trx Modes); Frc - Output Side (Rx Mode) - Lightware UBEX-PRO20-HDMI-F100 User Manual

 
     
6. Lightware Device Controller (LDC) 6. Lightware Device Controller (LDC)
6.5.7. Scaler Panel - Output Side (RX/TRX Modes)
Clicking on the Scaler panel on the HDMI output 1 of the receiver/transceiver opens the Scaler properties.
This feature allows to rescale the incoming stream to other resolution and refresh rate and fit to the sink
device. #scaler #csc #colorspace #colorrange
The most important signal and display information and settings are available on the panel.
Scaler panel for the HDMI out 1 (RX)
Available settings and tools:
▪
Scaling mode
– Passthrough: the scaler is in pass-through mode.
– Forced resolution: the scaling is active, the selected value in the forced resolution option will be
applied on the video signal;
– EDID based: the scaler forces the resolution which is read out from the EDID of the connected sink
device.
▪ Forced resolution: list of the available resolutions with refresh rate values. The selected one will be
applied on the video signal. See the available resolution in the
▪ Image position (Stretch / Fit / Center)
▪ Color space conversion (No conversion / RGB / YCbCr 4:4:4 / YCbCr 4:2:2);
Color range (No conversion / Full range / Limited range);
▪
▪ No Sync Screen (Test Pattern) settings;
▪ Signal freeze button: the signal freezes at the last video frame on the sink device (the sink may show a
broken frame either). #freeze
▪ Reloading factory default settings for the selected port.
series – Extender Application Mode – User's Manual series – Extender Application Mode – User's Manual
Resolutions of the Scaler / FRC section.
Applied F-series endpoint firmware package: v2.0.0 | Applied R-series endpoint firmware package: v2.0.0 | LDC software: v2.5.9b3
6.5.8. FRC - Output Side (RX Mode)
Clicking on the FRC (Frame Rate Converter) panel on the HDMI output 2 of the receiver opens the properties
of the Frame rate converter. #frc #csc #colorspace #colorrange
FRC panel for the HDMI out 2 (RX)
Available settings and tools:
▪
Output resolution mode
– Passthrough: the FRC is in pass-through mode.
– Forced resolution: the FRC is active, the selected value in the forced resolution option will be
applied on the video signal;
– EDID based: the FRC forces the resolution which is read out from the EDID of the connected sink
device.
▪ Forced resolution: list of the available resolutions with refresh rate values. The selected one will be
applied on the display device. See the available resolution in the
section.
▪ Color space conversion (No conversion / RGB / YCbCr 4:4:4 / YCbCr 4:2:2);
▪ Color range (No conversion / Full range / Limited range);
▪ No Sync Screen (Test Pattern) settings;
▪ Signal freeze button: the signal freezes at the last video frame on the sink device (the sink may show a
broken frame either). #freeze
Reloading factory default settings for the selected port.
▪
77 77
Resolutions of the Scaler / FRC