7.2.9
Replacing the 10 x 2.5-inch HDD backplane
Field Replaceable Unit
(FRU)
Tools: Phillips PH2 / (+) No. 2 screw driver (for removing/installing SAS
expander board)
7.2.9.1
Preliminary steps
"Locating the defective server" on page 50
Ê
"Shutting down the server" on page 53
Ê
"Disconnecting the power cord" on page 54
Ê
"Getting access to the component" on page 55
Ê
Ê Release all HDD/SSD modules and pull them out a few centimeters, see
section
"Removing 2.5-inch HDD/SSD modules" on page 147
I
The HDD/SSD modules need not to be removed. But if you want to
remove them nevertheless, check if all HDD/SSD modules are
uniquely identified so that you can reinsert them into their original
bays.
7.2.9.2
Removing the SAS expander board
Figure 73: Disconnecting power cable from the HDD backplane
Ê Disconnect the power cable from the HDD backplane.
RX1330 M3
Hard disk drive (HDD) / solid state drive (SSD)
Upgrade and Maintenance Manual
Hardware: 15 minutes
157