Condition Errors 301 To 399, Uncalibrated Integrity - Keysight n9020a Service Manual

Instrument Messages
Condition Messages
Err# Bit in Message
status
register
217 7
Demod Error;No
full subframe
found
217 7
Demod Error;Muxed
bits not found
217 7
Demod Error;Acq
Time too short
219 8
Signal Too Noisy
221 9
Slot Error
221 9
Slot error;No
active slot found
221 9
Slot Error; No
idle slot found
223 10 unused
225 11 unused
227 12 unused
229 13 unused
231 14 unused

Condition Errors 301 to 399, Uncalibrated Integrity

This series of errors corresponds to the bits in the
STATus:QUEStionable:INTegrity:UNCalibrated sub-register. The
second column in the table shows the corresponding bit in that register.
Error or More Information
Warning
E No sub-frame or only part of one sub-frame is detected.
E Multiplexed Data Demod Bits are not generated even
though Data channel is selected, because all 16 data
code channels are not active
E For Bluetooth, the detected packet type doesn't
match the captured packet type because the payload
start, end or data could not be found.
E NADC & PDC: The valid EVM measurement cannot be
performed, because the input signal is too noisy.
GSM & EDGE: In a GSM measurement, indicates that a
burst could not be found in a signal that appears noisy.
In PSA, this error was reported as one of the following
error numbers: 10702, 10824, 10906, 10930, 13024,
10626, 111
E
E No valid active slot found in captured data, or no active
slot found in captured interval. Synchronization may
succeed and pilot found when this message is issued,
but no results are included in peak/average calculation.
E No valid idle slot found in captured data, or no idle slot
found in captured interval. Synchronization may
succeed and pilot found when this message is issued,
but no results are included in peak/average calculation.
E
E
E
E
E
127