Canon imageRUNNER ADVANCE C3500 III Series Service Manual page 1176

Super G3 2nd Line Fax Board-
AU1
Points to Note at Installation
• Although pictures or illustrations used for explanation
may differ from the actual things, the procedure is the
same.
• When installing the Super G3 FAX Board and this
equipment at the same time, be sure to install them by
referring to this document after checking "Checking the
Contents" of Super G3 FAX Board.
CAUTION:
Marked portion
When tightening the screws, do not tighten them too
tightly. Otherwise, there is a risk of damage and
deformation of screw holes.
Essential Items to Be
Performed Before Installation
• Turn OFF the main power of the host machine, and
disconnect the power plug from the outlet.
WARNING:
• If performing work without disconnecting the
power plug of the host machine, it may cause
electrical shock.
• If disconnecting the power plug without
turning OFF the main power, it may cause
damage of the machine.
• When turning OFF the main power, follow the below
procedure.
1. Turn OFF the main power switch of the host
machine.
2. The display in the Control Panel and the lamp of the
main power are turned off.
Points to Note when turning
ON/OFF the main power
The following message is displayed.
1. When a message prompting to turn OFF and then ON
the main power appears, turn OFF and then ON the main
power switch.
2. If a message prompting the user to update the version
appears, press [Update] to automatically update the
version of this equipment.
If [Skip] is selected, a message prompting the user to
update the version will appear every time the host
machine is started. In the service mode ( Lv.2 ) shown
below, it is possible to set not to display the message.
COPIER > OPTION > FNC-SW > VER-CHNG
Installation Outline Drawing
1154
9. Installation