Defining Cutting Planes - Siemens SINUMERIK 840D sl Operating Manual

Simulating machining
7.9 Displaying simulation alarms
7.8.5

Defining cutting planes

In the 3D view, you have the option of "cutting" the workpiece and therefore displaying certain
views in order to show hidden contours.
Precondition
The simulation or the simultaneous recording is started.
Procedure
...
7.9 Displaying simulation alarms
Alarms might occur during simulation. If an alarm occurs during a simulation run, a window
opens in the operating window to display it.
186
Press the "Magnify -" or <-> softkey to reduce the frame.
- OR -
Press one of the cursor keys to move the frame up, down, left or right.
4. Press the "Accept" softkey to accept the selected section.
1. Press the "Details" softkey.
2. Press the "Cut" softkey.
The workpiece is displayed in the cut state.
3. Press the corresponding softkey to shift the cutting plane in the required
direction.
Operating Manual, 05/2017, A5E40868517
Universal